GDTG-600A Cable Fault Locator

● Combining both TDR and Bridge testing modes, which can be used for such faults as break, mix and defective insulation of the cable. The bridge method only applies to communication cables.

● Automatic measurement to find fault point

● Manual measurement is also available.

● Easy to use Menu driven operation

● With functions of megohmmeter and ohmmeter, it can test insulation resistance and loop resistance. This function is only used with communication cables.

● 10 test waveforms can be stored permanently even there is a power off.

● Adopt automatic gain and automatic impedance balance technology to replace the tedious potentiometer adjustment.

● High resolution backlight LCD display.

● Using rechargeable lithium battery, intelligent charging, no need to be on duty.

● Small size, light weight, simple operation.

TDR Mode

● Max. Measurement distance: 8km, the range can be set according to length of the cable.

● Measurement dead zone: 0m

● Measurement accuracy: 1m (Range<2km), 8m (Range>2km)

● Pulse width: 80ns-10μs, automatic adjustment.

● Automatic adjustment of impedance balance.

● Automatic and manual modes of gain adjustment.

Intelligent bridge measurement mode(suitable for communication cable)

● Max Resistance of defective insulation: 100MΩ

● Measurement accuracy: ±1% x length of the cable

● Max. Measurement range: 9999m

● Input by three segments, and the wire radius is 0.3mm-0.99mm

Recharge time: 3.5 hours

Dimension: 230x150x160(mm)

Weight: 2kg